![]() Download diypack22.zip from Unzip and run setup.exe. You will need to buy a standard A-B USB cable to connect from your PC to K150. The USB connector is a standard ‘B’ type. Make sure the crystal is mounted 2-3mm above the PCB so the case cannot make contact with the pads on the top layer or the R19 resistor. Solder the lowest height thru-hole components first. But some thru-hole components have been left for the buyer to solder. Most components – resistors, transistors and 2 Ics - are already presoldered onto the PCB. Color photos of the assembled Kit can be found at The photos are with an optional ZIF socket. There are 14 through-hole components for the buyer to solder. ![]() Most of the components – resistors, some capacitors, transistors and two ICs – are surface mount and are presoldered on the board. USB PIC PROGRAMMER This is the third in a series of three PIC Programmers designed by Tony Nixon. This documentation was written August 25, 2004. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |